Tygris IS9 Mould Release Light
A light duty release agent for delicate moulds. Mould Release 8 has a reduced silicone content of about 8% for the release of delicate plastic mouldings. This is particularly useful where marking of the plastic might otherwise occur. Used to give fine and lasting lubrication in a wide range of industrial applications, it is stable to 300C.
Benefits:
8% silicone for delicate and small mouldings
No other additives
Good flow properties
Colourless and non-marking
Safe and odourless
Gives lasting lubrication
Heat stable to 300C
Technical Data:
Appearance: Colourless slightly viscous liquid
Odour: Slightly sweet when solvent has evaporated
Contents: Blend of silicone polymer and naphtha with hydrocarbon propellants
Storage: Below 50C
Flash Point: <0C
Solubility: Insoluble in water
Temperature range: Up to 200C (Continuous) 250C Intermittent
Specific Gravity: 0.795
Size: 400ml can
Directions for Use:
Ensure surface to be treated is clean and dry.
Shake can well before use and spray evenly from 20 to 30cm.
Do not overspray.
Allow 1 to 2 minutes for carrier solvent to evaporate.