R218 Moly Dry Film Lubricant
Effective alternative to wet oils. A molybdenum disulphide based lubricant for use where conventional wet oils would be undesirable. Particularly suitable for the assembly and running-in of gears, bearings, spindles and valves, it is effective for use where high temperatures occur, drying to a tough, matt black high slip coating.
Benefits:
Dry Lubricant does not attract dirt
Durable coating
Outstanding adhesion
Extended service life
Withstands high loads
Working temperature to at least 350C
Water and chemical resistant
Anti static properties
Technical Data:
Appearance: Black semi-fluid liquid drying to a solid matt black film
Odour: Strong organic ester odour
Contents: Blend of graphite, Molybdenum Disulphide (MoS²) solids, PTFE, extreme pressure additives and acrylic resin in a solvent blend consisting of ethyl acetate, 1-methoxy-2-propanol, 2botoxyethanol, acetone, ethanol and solvent naphtha in demethyl ether propellant. MoS² content 12½% in base product, 6% in laid down film
Storage: Below 50C
Flash Point: <0C
Temperature range: 250C continuous 400C intermittent
Relative density: 0.915
Sizes: 400ml can
Directions for Use:
Shake can well before use and spray from a distance of 25-30cm onto a clean dry surface.
The acrylic binder will degrade above 110C leaving active film on the surface
Wipe off any excess.
Touch dry in 5 minutes.
